Home        Installing Scenery   


Creating Airport Scenery : Roads and Pylons

Return               Exclusion 

Roads and lines of pylons are generated from Open Street Map (OSM) data and positioned onto the default scenery as lines and strings between marked nodes.  The roads are quite accurately positioned, but they are a case of "one road fits all" and motorways are often dual roads.  Where the OSM data altitude differs from X-Plane default, the sim can often generate raised bridges to lift the road.  This is a known issue in default X-Plane 10.  

Roads can be removed with an exclusion zone.  Such an action will remove any road that is covered by the exclusion zone - to the next node outside of the exclusion zone.
    [Exclude Roads]

OSM shows a variety of pylon types with a single aligned symbol. The XP default pylons are represented as a "one pylon fits all" situation with no difference between a 7 cable steel tower pylon and a 1 cable wooden post.  They are also positioned by an algorythm so they do not match the pylon positions on the ground.

Pylons can also be removed by placing an exclusion zone across the line of pylons.  Such an exclusion will again, remove the line of pylons from under the zone to the next node outside of the zone and also exclude any roads.
    [Exlude Roads]

Note:  Excluding a line of pylons works with small exclusion zones between the nodes - take care not to cover parts of roads.  If you are using Ortho scenery which includes road surfaces, you can use a large exclusion zone, but you may loose AI road traffic.

Most airport designers will remove some roads near airports and replace them with more realistic scenery textures.