Home        Installing Scenery   


Creating Airport Scenery : Runway Texture

Return
X-Plane default runways are a bit simplistic when compared to the real world.  The runway grass surface and the gravel present the most difficult comparison with reality.  With the default texture, the runways stand out in the scenery, but in the real world, grass and hardcore runways are often difficult to spot.

Basic Ideas.

polygons can be created to lay down the texture for grass and gravel.  The process is simple and easily acheived.

   1. Produce a square texture image that is seamless and able to link together on all sides.
   2. Write a short .pol file to express the texture on the scenery.


Using such texture files in WED, the runway can be placed and different grass textured polygons can be assembled around it.  If the gravel texture on the runway is set at markings -1, the runway texture will be covered by the gravel.  Other settings may require the runway to be set to transparent.

Note:  Polygons set to the same level must not overlap, or they will flicker on screen.


Here are two examples of runways set as a gravel strip and a grass strip. (not to scale)

Gravel runway.

  1. Position the runway on the scenery.

  2. Put a gravel polygon over the runway, to include any turnarounds and aprons. Set the orientation.

  3. Surround the runway using a grass polygon - or if the texture requires, several grass or dirt polygons.

Note:  The runway roughness needs to be set to 1 (or an appropriate value).  The runway can be set to 'surface transparent' if the polygon surface texture is set too low in the layering.

   Roughness Guide:    Asphalt = 0.0 to 0.4     Grass = 0.4 to 0.8     Gravel = 0.6 to 1.0     Hardcore = 0.3 to 0.8


Grass Runway.

  1. Position the runway on the scenery.

  2. Place a grass polygon across the whole airfield area and use the hole tool to cut out a slot over the runway.

  3. Position a different texture grass polygon over the runway. Set the orientation of the texture.

There are many variations of this technique.  Grass apron areas can be defined as a texture the same as the runway, or a different texture.  dirt, asphalt, tarmac, gravel and concrete textures can be used.  - don't forget to set the runway roughness.

Note: If the runway is set to dirt and overlayed with a texture in the markings layer, the dust blown effect from an aircraft propeller will happen.

Here is a basic polygon texture sets to use in your scenery, or bungle with any freeware you produce.

GrassAndGravel.zip

 The textures and levels can be amended to suit your needs.  You can alter the .pol files for texture scale (set at 8m square in each case here), use the alpha setting to make them reflective, adjust the layer levels: Airport -1, 1, 2 ; Scenery -1, 1, 2 ; as appropriate.  Level 0 is the default.  Airport -1 will place the polygon below the runway and Scenery -1 will place it above the runway but below the additional runway markings.